TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
98 Johnson 25hp J25TEECB Starter Solenoid Wiring Diagram
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="perchjerker" data-source="post: 407997" data-attributes="member: 20605"><p>I would say you are correct, but to make sure-</p><p></p><p>turn the ignition switch to the crank position. put a volt meter on the wires and see which one has battery voltage when cranking</p><p></p><p>connect this to #3</p><p></p><p>one of the remaining wires should go to ground. take your ohm meter to check which one it is.</p><p></p><p>hook that to the other small post.</p><p></p><p>Now try cranking the motor, it should turn over.</p><p></p><p>the other wire with the blue crimp is probably for power for a depth finder or something like that, it does not look like a factory connection.</p><p></p><p>you would just need to find a post that has 12 v power for that one, it might go to the larger B+ battery post</p><p></p><p>the 2 large wires already on the solenoid, did you hook those up or were they already there? he replaced the starter or the solenoid? Or both?</p></blockquote><p></p>
[QUOTE="perchjerker, post: 407997, member: 20605"] I would say you are correct, but to make sure- turn the ignition switch to the crank position. put a volt meter on the wires and see which one has battery voltage when cranking connect this to #3 one of the remaining wires should go to ground. take your ohm meter to check which one it is. hook that to the other small post. Now try cranking the motor, it should turn over. the other wire with the blue crimp is probably for power for a depth finder or something like that, it does not look like a factory connection. you would just need to find a post that has 12 v power for that one, it might go to the larger B+ battery post the 2 large wires already on the solenoid, did you hook those up or were they already there? he replaced the starter or the solenoid? Or both? [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
98 Johnson 25hp J25TEECB Starter Solenoid Wiring Diagram
Top