TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
a new jet ski jet boat project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="scubapro820" data-source="post: 246566" data-attributes="member: 7883"><p>I made my motor mounts last night, theyre just kinda resting and not bolted in yet or shimmed up but it'll go pretty well I think. btw I used a lincoln weldpack 3200hd with 5356 wire and 6061/63 alloy metals It takes a ton of pre heating with a map torch but once the whole piece is good and hot the welder had no problems no feed issues at all! and to think I was starting to think I hated aluminum.</p></blockquote><p></p>
[QUOTE="scubapro820, post: 246566, member: 7883"] I made my motor mounts last night, theyre just kinda resting and not bolted in yet or shimmed up but it'll go pretty well I think. btw I used a lincoln weldpack 3200hd with 5356 wire and 6061/63 alloy metals It takes a ton of pre heating with a map torch but once the whole piece is good and hot the welder had no problems no feed issues at all! and to think I was starting to think I hated aluminum. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
a new jet ski jet boat project
Top