TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Off The Water
Watering Hole
Add a DIY milling table to your drill press
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="LDUBS" data-source="post: 428416" data-attributes="member: 21536"><p>IMO, this is the kind of tool that needs to be dead bang on and needs to hold whatever setting is dialed in. If not, there will be much frustration. I have fabricated some tools in the past, but not sure I would take this on. I give him credit for taking it on.</p></blockquote><p></p>
[QUOTE="LDUBS, post: 428416, member: 21536"] IMO, this is the kind of tool that needs to be dead bang on and needs to hold whatever setting is dialed in. If not, there will be much frustration. I have fabricated some tools in the past, but not sure I would take this on. I give him credit for taking it on. [/QUOTE]
Verification
Post reply
Forums
Off The Water
Watering Hole
Add a DIY milling table to your drill press
Top