TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Alumacraft 1648 MV NCS vs Lowe Aura 1648
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="jtf" data-source="post: 450743" data-attributes="member: 22611"><p>I don't work for any dealer or boat company. I run or have owned six welded boats including a Lowe 1648 tunnel which was a good flat bottom run about. </p><p></p><p> I almost purchased the Alumacraft last year, it was a toss up between it and Alweld Marsh series, after smoking all three over side by side at a board sponsor's lot. There was about $100 difference in all three. Didn't notice that much difference between the Lowe and Alumacraft.</p><p></p><p>Off topic, sorry, but have you looked at Alwed Marsh? The weld quality and fit/finish is very good, no side ribs great use of space. Was within a week of putting down a deposit on one, found a good deal on a barely used Weldbilt close by sitting on a trailer. Runs a tiller jet.</p></blockquote><p></p>
[QUOTE="jtf, post: 450743, member: 22611"] I don't work for any dealer or boat company. I run or have owned six welded boats including a Lowe 1648 tunnel which was a good flat bottom run about. I almost purchased the Alumacraft last year, it was a toss up between it and Alweld Marsh series, after smoking all three over side by side at a board sponsor's lot. There was about $100 difference in all three. Didn't notice that much difference between the Lowe and Alumacraft. Off topic, sorry, but have you looked at Alwed Marsh? The weld quality and fit/finish is very good, no side ribs great use of space. Was within a week of putting down a deposit on one, found a good deal on a barely used Weldbilt close by sitting on a trailer. Runs a tiller jet. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Alumacraft 1648 MV NCS vs Lowe Aura 1648
Top