TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Alumacraft 1648 Project - Getting Ready, Again
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="gillhunter" data-source="post: 262698" data-attributes="member: 5151"><p>Getting ready to go to Michigan to fish for a week at the end of the month. So I put the Honda back on today. I installed a bilge pump over the winter, and we have been fishing total electric this spring. I was concerned that my gas tank would bounce around and hit the bilge pump. I didn't want to install something to secure the tank that would block my access to the drain plug. After thinking up a lot of bad solutions I decided to just install a bungee cord. I drilled a couple of hole in the transom braces to locate the bungee. I think it is going to work ok.</p></blockquote><p></p>
[QUOTE="gillhunter, post: 262698, member: 5151"] Getting ready to go to Michigan to fish for a week at the end of the month. So I put the Honda back on today. I installed a bilge pump over the winter, and we have been fishing total electric this spring. I was concerned that my gas tank would bounce around and hit the bilge pump. I didn't want to install something to secure the tank that would block my access to the drain plug. After thinking up a lot of bad solutions I decided to just install a bungee cord. I drilled a couple of hole in the transom braces to locate the bungee. I think it is going to work ok. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Alumacraft 1648 Project - Getting Ready, Again
Top