TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Alumacraft 1648 Project - Getting Ready, Again
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Floydp680" data-source="post: 264161" data-attributes="member: 8841"><p>Hello gillhunter. A few days ago I brought home my new 1648/20 and a new trailer. I was wondering if you used 1/2" ply everywhere or not. I'm doing a similar but probably more basic floor. I'm doing doing wood and carpet on the back bench, on the ends of the middle bench, on the front deck, and on the 2 floor sections. On the floor I'm probably doing each section with 2 pieces of wood that meet in the middle. I was considering using more than 1/2" ply for the 2 floor sections because I am worried about flex, or a soft feel to the floor near the benches where it will essentially just be floating because the ribs are not right against the benches.</p></blockquote><p></p>
[QUOTE="Floydp680, post: 264161, member: 8841"] Hello gillhunter. A few days ago I brought home my new 1648/20 and a new trailer. I was wondering if you used 1/2" ply everywhere or not. I'm doing a similar but probably more basic floor. I'm doing doing wood and carpet on the back bench, on the ends of the middle bench, on the front deck, and on the 2 floor sections. On the floor I'm probably doing each section with 2 pieces of wood that meet in the middle. I was considering using more than 1/2" ply for the 2 floor sections because I am worried about flex, or a soft feel to the floor near the benches where it will essentially just be floating because the ribs are not right against the benches. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Alumacraft 1648 Project - Getting Ready, Again
Top