TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Alumacraft 1648 Project - Getting Ready, Again
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="gillhunter" data-source="post: 319516" data-attributes="member: 5151"><p>I just determined the location, including the direction of the discharge, marked it on the pump base and hull with a pencil. The I removed the base from the pump, put the 3M on the base, stuck it to the hull and let it set up for 24 hours before I did any more of the installation.</p></blockquote><p></p>
[QUOTE="gillhunter, post: 319516, member: 5151"] I just determined the location, including the direction of the discharge, marked it on the pump base and hull with a pencil. The I removed the base from the pump, put the 3M on the base, stuck it to the hull and let it set up for 24 hours before I did any more of the installation. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Alumacraft 1648 Project - Getting Ready, Again
Top