TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
Jet Boat Projects
Alumacraft Jet Jon Project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="CedarRiverScooter" data-source="post: 384909" data-attributes="member: 15465"><p>Sounds like that would be the ultimate solution. I remember having the 'most shallow' draft as my main goal when I started, doesn't seem very important now. Could you just leave the hull center solid, & weld the delta panel over it (except where the pump goes of course)? That is what I though of for a deadrise panel. Then taper at front to blend in with the bow.</p><p></p><p>A seconday benefit of a drop down center would be better tracking (I would think). The slide is kinda fun but have to slow down in tight corners.</p><p></p><p>I used 5356 in my welding because I have a old millermatic, no spool gun, & it wouldn't push 4043. 5356 would push MOST of the time!</p></blockquote><p></p>
[QUOTE="CedarRiverScooter, post: 384909, member: 15465"] Sounds like that would be the ultimate solution. I remember having the 'most shallow' draft as my main goal when I started, doesn't seem very important now. Could you just leave the hull center solid, & weld the delta panel over it (except where the pump goes of course)? That is what I though of for a deadrise panel. Then taper at front to blend in with the bow. A seconday benefit of a drop down center would be better tracking (I would think). The slide is kinda fun but have to slow down in tight corners. I used 5356 in my welding because I have a old millermatic, no spool gun, & it wouldn't push 4043. 5356 would push MOST of the time! [/QUOTE]
Verification
Post reply
Forums
Jet Boats
Jet Boat Projects
Alumacraft Jet Jon Project
Top