TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
Jet Boat Projects
Alumacraft Jet Jon Project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="badrider77" data-source="post: 423324" data-attributes="member: 17307"><p>Thanks for the advice fellas. When I built mine it has somewhat of a spoon from where I hammered the bottom of the boat to fit hull. I was looking at it today and the spoon is lower than the leading edge of the intake. I think that will need some work. Plus my boat is a 2052 so I'm not sure if the length has an affect on the cavitation. I'll post some pics of the spoon and would be open to any feedback.</p></blockquote><p></p>
[QUOTE="badrider77, post: 423324, member: 17307"] Thanks for the advice fellas. When I built mine it has somewhat of a spoon from where I hammered the bottom of the boat to fit hull. I was looking at it today and the spoon is lower than the leading edge of the intake. I think that will need some work. Plus my boat is a 2052 so I'm not sure if the length has an affect on the cavitation. I'll post some pics of the spoon and would be open to any feedback. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
Jet Boat Projects
Alumacraft Jet Jon Project
Top