TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
Jet Boat Projects
Alumacraft MV1448 Seadoo IB jet, Still jetting
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Flatbotm" data-source="post: 216603" data-attributes="member: 6226"><p>Hey Jaime,</p><p>I picked up the golf club tubes today for .47cents each. Unfortunately I missed the part about the holes needing to be 1.40. I'm going to try 1 and 3/8 and using the die grinder to round it the extra bit. Or I thought of punching the holes to 1.5 and using some rubber edge trim to snug them up. I have a tool for my plasma for cutting circles but I'm not sure if I can go that small. Any other ideas?</p><p>Thanks</p><p>Selby</p></blockquote><p></p>
[QUOTE="Flatbotm, post: 216603, member: 6226"] Hey Jaime, I picked up the golf club tubes today for .47cents each. Unfortunately I missed the part about the holes needing to be 1.40. I'm going to try 1 and 3/8 and using the die grinder to round it the extra bit. Or I thought of punching the holes to 1.5 and using some rubber edge trim to snug them up. I have a tool for my plasma for cutting circles but I'm not sure if I can go that small. Any other ideas? Thanks Selby [/QUOTE]
Verification
Post reply
Forums
Jet Boats
Jet Boat Projects
Alumacraft MV1448 Seadoo IB jet, Still jetting
Top