TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Aluminum VS Ext Plywood for Casting Deck and Floor
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="heavyduty" data-source="post: 206628" data-attributes="member: 4412"><p>I just had a floor put in my new Alumacraft 1442 NCS. Using closed cell foam to fill the space between the ribs and make it flush with the top of the ribs, I then used .062 aluminum. My ribs were roughly 14" apart also. I'm 320lbs and it supports me just fine. I used the .125 to extend the front casting deck since it was not fully supported with foam like the floor.</p><p>HD</p></blockquote><p></p>
[QUOTE="heavyduty, post: 206628, member: 4412"] I just had a floor put in my new Alumacraft 1442 NCS. Using closed cell foam to fill the space between the ribs and make it flush with the top of the ribs, I then used .062 aluminum. My ribs were roughly 14" apart also. I'm 320lbs and it supports me just fine. I used the .125 to extend the front casting deck since it was not fully supported with foam like the floor. HD [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Aluminum VS Ext Plywood for Casting Deck and Floor
Top