TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Angled board cuts for bracing
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="russ010" data-source="post: 113139" data-attributes="member: 677"><p>for the angle, measure the top where the top of your brace will be to the other side... then measure the bottome the same way. </p><p></p><p>So, if your top length is 54" (from one side to the other), and your bottom measurement is 36", then the difference between the top and bottom is 18" - meaning you will have 9" to cut off the bottom side.</p><p></p><p>When you figure out the height, you will start at the top of your angle, measure down the height between top and bottom, then measure over 9" and mark that as your starting point for the floor.</p><p></p><p>hold on, I'll draw you a pic... errr... maybe not - photobucket is not working for me right now</p></blockquote><p></p>
[QUOTE="russ010, post: 113139, member: 677"] for the angle, measure the top where the top of your brace will be to the other side... then measure the bottome the same way. So, if your top length is 54" (from one side to the other), and your bottom measurement is 36", then the difference between the top and bottom is 18" - meaning you will have 9" to cut off the bottom side. When you figure out the height, you will start at the top of your angle, measure down the height between top and bottom, then measure over 9" and mark that as your starting point for the floor. hold on, I'll draw you a pic... errr... maybe not - photobucket is not working for me right now [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Angled board cuts for bracing
Top