TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Anyone create FRP Board and Polystyrene sandwich for decking.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="fwman1" data-source="post: 493612" data-attributes="member: 31515"><p>Finally got to work on this today. I used a 4" metal cutoff disc in a grinder to trim the edges of the glued sheets. I then used 80 grit belt sander to finish the edges. I'll put a final coat of epoxy on these sanded edges before final installation.</p><p></p><p>TEST! Supported only on 3 sides. I can stand in the middle and hop up and down and it is solid as a rock.</p><p>[ATTACH=full]113139[/ATTACH]</p><p></p><p></p><p></p><p></p><p></p><p>[ATTACH=full]113140[/ATTACH]</p><p>[ATTACH=full]113141[/ATTACH]</p><p></p><p>I will add some center bracing just because it doesn't weigh much, but I think it is actually overkill.</p></blockquote><p></p>
[QUOTE="fwman1, post: 493612, member: 31515"] Finally got to work on this today. I used a 4" metal cutoff disc in a grinder to trim the edges of the glued sheets. I then used 80 grit belt sander to finish the edges. I'll put a final coat of epoxy on these sanded edges before final installation. TEST! Supported only on 3 sides. I can stand in the middle and hop up and down and it is solid as a rock. [ATTACH type="full"]113139[/ATTACH] [ATTACH type="full"]113140[/ATTACH] [ATTACH type="full"]113141[/ATTACH] I will add some center bracing just because it doesn't weigh much, but I think it is actually overkill. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Anyone create FRP Board and Polystyrene sandwich for decking.
Top