TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Benjineer's Lund S-16 Mod
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="benjineer" data-source="post: 155335" data-attributes="member: 3833"><p>I'd need a tie bar for trips or weld something on the existing tie bar. I might have to start over because I'm not sure there's room for a third with the spacing as it is. I seriously doubt I'll go there. If 20hp is not enough, I'll probably sell them and buy a single 35 or 40.....or 2 20s...hmmm.</p></blockquote><p></p>
[QUOTE="benjineer, post: 155335, member: 3833"] I'd need a tie bar for trips or weld something on the existing tie bar. I might have to start over because I'm not sure there's room for a third with the spacing as it is. I seriously doubt I'll go there. If 20hp is not enough, I'll probably sell them and buy a single 35 or 40.....or 2 20s...hmmm. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Benjineer's Lund S-16 Mod
Top