TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Boat mods DO's and DON'Ts for newbies?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="assaultcraft8993" data-source="post: 306016" data-attributes="member: 10956"><p>I am also a "newbie" to the aluminum boat mods. I have a question about the supports pictured here in my picture. Can I get rid of them and replace with something that will allow me to install a storage box down the sides for either rods or tackle? They were attached to the old bench seats. Also the transom has the old wood taken out and ready to be put back in NEW, in the picture it only went from top to flush under the angle going from side to side, but the new one I made is going back in from top to bottom of transom. Will this give it better support since there was no support brackets other then what is shown in the pictures? The old owner said he used a 40hp OB but wasn't on there when I bought it. So I don't want to try it with here say...</p><p>This is a 1961 Lone Star 16' semi v-hull</p></blockquote><p></p>
[QUOTE="assaultcraft8993, post: 306016, member: 10956"] I am also a "newbie" to the aluminum boat mods. I have a question about the supports pictured here in my picture. Can I get rid of them and replace with something that will allow me to install a storage box down the sides for either rods or tackle? They were attached to the old bench seats. Also the transom has the old wood taken out and ready to be put back in NEW, in the picture it only went from top to flush under the angle going from side to side, but the new one I made is going back in from top to bottom of transom. Will this give it better support since there was no support brackets other then what is shown in the pictures? The old owner said he used a 40hp OB but wasn't on there when I bought it. So I don't want to try it with here say... This is a 1961 Lone Star 16' semi v-hull [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Boat mods DO's and DON'Ts for newbies?
Top