TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Bow mount trolling motor on Grizzly Issue
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="fl.graderman" data-source="post: 407103" data-attributes="member: 20523"><p>Gpmd,</p><p>I completed my trolling motor install today and honestly, you won't need those isolator bolts or any kind of anchors. Just do what Killintime said previously and pop that plate off. There's plenty of room to get in there and tighten nuts down.</p><p><img src="https://uploads.tapatalk-cdn.com/20160228/5b25e09e92f6150531c321cf6ead6095.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" /></p><p>Also I saw on your other thread where you were wanting to run cables from bow to stern in pvc conduit...</p><p>While that plate is off, about 8" or so straight below it, I found a chase that goes under the floor to the stern sheet. I found it accidentally and could only see it once I cut some foam away from it. </p><p><img src="https://uploads.tapatalk-cdn.com/20160228/e906f2a9ab3b8c5f9c19b8127f04432e.jpg" alt="" class="fr-fic fr-dii fr-draggable " style="" /></p><p>Tracker said there was one there, but I couldn't figure out where until today.</p><p>Once you get that plate off, everything becomes pretty obvious. Good luck.</p><p></p><p>2015 Tracker Grizzly 1448 MVX</p><p>1996 Evinrude 25hp 3 cylinder looper</p></blockquote><p></p>
[QUOTE="fl.graderman, post: 407103, member: 20523"] Gpmd, I completed my trolling motor install today and honestly, you won't need those isolator bolts or any kind of anchors. Just do what Killintime said previously and pop that plate off. There's plenty of room to get in there and tighten nuts down. [img]https://uploads.tapatalk-cdn.com/20160228/5b25e09e92f6150531c321cf6ead6095.jpg[/img] Also I saw on your other thread where you were wanting to run cables from bow to stern in pvc conduit... While that plate is off, about 8" or so straight below it, I found a chase that goes under the floor to the stern sheet. I found it accidentally and could only see it once I cut some foam away from it. [img]https://uploads.tapatalk-cdn.com/20160228/e906f2a9ab3b8c5f9c19b8127f04432e.jpg[/img] Tracker said there was one there, but I couldn't figure out where until today. Once you get that plate off, everything becomes pretty obvious. Good luck. 2015 Tracker Grizzly 1448 MVX 1996 Evinrude 25hp 3 cylinder looper [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Bow mount trolling motor on Grizzly Issue
Top