TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Bracket for bow mount trolling motor
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="MN Fisher" data-source="post: 489008" data-attributes="member: 31421"><p>This is just a mock-up using some scrap I had laying around...done so I can get measurements to cut the final pieces</p><p></p><p>[ATTACH=full]111307[/ATTACH]</p><p>[ATTACH=full]111308[/ATTACH]</p><p></p><p>1/8"x2" angle for the base - those will be through-bolted to the platform</p><p>1/8"x3/4" angle to support the 1/8"x6"x20" sheet that the TM mount bolts to</p><p>1/8" sheet cut to proper dimensions to connect the 2" and 3/4" angle</p><p></p><p>Looks a little 'front' heavy, but the actual front end of the TM mount rests on the bow-plate for support there. TM shaft will be 2" from the nose directly on the centerline.</p></blockquote><p></p>
[QUOTE="MN Fisher, post: 489008, member: 31421"] This is just a mock-up using some scrap I had laying around...done so I can get measurements to cut the final pieces [ATTACH type="full" alt="20220504_143338-1.jpg"]111307._xfImport[/ATTACH] [ATTACH type="full" alt="20220504_143348-1.jpg"]111308._xfImport[/ATTACH] 1/8"x2" angle for the base - those will be through-bolted to the platform 1/8"x3/4" angle to support the 1/8"x6"x20" sheet that the TM mount bolts to 1/8" sheet cut to proper dimensions to connect the 2" and 3/4" angle Looks a little 'front' heavy, but the actual front end of the TM mount rests on the bow-plate for support there. TM shaft will be 2" from the nose directly on the centerline. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Bracket for bow mount trolling motor
Top