TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Can some one give the run down on a Johnson QD-10
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Pappy" data-source="post: 262115" data-attributes="member: 3278"><p>First and foremost...that engine MUST be run on a mixture of no less than 24:1 fuel/oil mix..... I don't care what Billy Bob or Bubba tell you! </p><p>Second.....service the engine completely and you will have an engine that is just about bulletproof if you run it sensibly and take care of it. The water pump should be serviced. The gearcase oil should be checked, changed, and probably re-seal the gearcase. The ignition system should be checked, updated as necessary, and set. The carburetor should be cleaned and a new kit, including a new float, should be installed. From this point that engine is a real bear power wise and a pleasure to run.</p></blockquote><p></p>
[QUOTE="Pappy, post: 262115, member: 3278"] First and foremost...that engine MUST be run on a mixture of no less than 24:1 fuel/oil mix..... I don't care what Billy Bob or Bubba tell you! Second.....service the engine completely and you will have an engine that is just about bulletproof if you run it sensibly and take care of it. The water pump should be serviced. The gearcase oil should be checked, changed, and probably re-seal the gearcase. The ignition system should be checked, updated as necessary, and set. The carburetor should be cleaned and a new kit, including a new float, should be installed. From this point that engine is a real bear power wise and a pleasure to run. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Can some one give the run down on a Johnson QD-10
Top