TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Carb Problem - Clueless to Problem Plz Help!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="kfx450r" data-source="post: 348285" data-attributes="member: 11663"><p>So after months of the engine running flawlessly, I go fishing and while idling through an extremely long idle zone in an area where I've always had problems for some reason, the carb started screwing up. It runs fine then about 30 seconds later gas starts spewing out of the top where that little plate with the two screws is then it dies, I can pump the bulb then turn on the choke and it'll start and run with the choke off for another 5 mins then the same thing happens, rinse repeat. I believe the top is a pathway for overflow gas to go from the float chamber, but I took it all apart cleaned every jet, passageway I could and it still does it.</p><p></p><p>I have absolutely no idea why its doing this and would greatly appreciate any help. Heres a picture with a bubble around where the gas is shooting out of.</p></blockquote><p></p>
[QUOTE="kfx450r, post: 348285, member: 11663"] So after months of the engine running flawlessly, I go fishing and while idling through an extremely long idle zone in an area where I've always had problems for some reason, the carb started screwing up. It runs fine then about 30 seconds later gas starts spewing out of the top where that little plate with the two screws is then it dies, I can pump the bulb then turn on the choke and it'll start and run with the choke off for another 5 mins then the same thing happens, rinse repeat. I believe the top is a pathway for overflow gas to go from the float chamber, but I took it all apart cleaned every jet, passageway I could and it still does it. I have absolutely no idea why its doing this and would greatly appreciate any help. Heres a picture with a bubble around where the gas is shooting out of. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Carb Problem - Clueless to Problem Plz Help!
Top