TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
cutting a drive shaft ??
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Pappy" data-source="post: 375101" data-attributes="member: 3278"><p>Charger....The driveshaft can be cut and re-welded. The cut and weld process can be made stronger and straight by drilling a pilot into one of the driveshaft parts and cutting a step into the other half which will then be pressed into the drilled portion. Chamfers should be cut into the halves and the welding and grinding done at that point. </p><p>Cutting and re-splining can be done as well but more expensive.</p><p>Shift shaft can be cut and the lower unit end can be machined as necessary. </p><p>Or.....Ebay....or....www.aomci.org </p><p>Bet someone over at aomci will have one to sell the parts off of if Ebay doesn't have anything.</p></blockquote><p></p>
[QUOTE="Pappy, post: 375101, member: 3278"] Charger....The driveshaft can be cut and re-welded. The cut and weld process can be made stronger and straight by drilling a pilot into one of the driveshaft parts and cutting a step into the other half which will then be pressed into the drilled portion. Chamfers should be cut into the halves and the welding and grinding done at that point. Cutting and re-splining can be done as well but more expensive. Shift shaft can be cut and the lower unit end can be machined as necessary. Or.....Ebay....or....www.aomci.org Bet someone over at aomci will have one to sell the parts off of if Ebay doesn't have anything. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
cutting a drive shaft ??
Top