TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Cutting Angles......That darn boat hull
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Flatliner" data-source="post: 282406" data-attributes="member: 7472"><p>try bending a piece of coat hanger wire or bare copper wire to fit the angle/radius, and then transfer to edge of wood. be careful, don't hurry Lay out is more important than cutting. and also more time consumming. I hope this helps....also measure width at top AND bottom of material (like 1/2 " plywood) that also helps.try a mockup of sheet insulation first. My shop was full of full sized patterns I only used once.. lol good luck!</p></blockquote><p></p>
[QUOTE="Flatliner, post: 282406, member: 7472"] try bending a piece of coat hanger wire or bare copper wire to fit the angle/radius, and then transfer to edge of wood. be careful, don't hurry Lay out is more important than cutting. and also more time consumming. I hope this helps....also measure width at top AND bottom of material (like 1/2 " plywood) that also helps.try a mockup of sheet insulation first. My shop was full of full sized patterns I only used once.. lol good luck! [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Cutting Angles......That darn boat hull
Top