TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Draft difference: Flat bottom vs. Mod Vee
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="dsuden" data-source="post: 317554" data-attributes="member: 11842"><p>The 1648 mv does really appeal to me. It's no-center-seat which I prefer. Suppose I put a 9.9 HP on the back of it. Would it ride pretty high in the water when going slowly? It's all about draft for me, and I'm going to be stuck with a prop (rather than a jet) due to cost. The fewer inches we go below the surface, the better. </p><p></p><p>So 1648 and a 9.9...a pretty good bet?</p></blockquote><p></p>
[QUOTE="dsuden, post: 317554, member: 11842"] The 1648 mv does really appeal to me. It's no-center-seat which I prefer. Suppose I put a 9.9 HP on the back of it. Would it ride pretty high in the water when going slowly? It's all about draft for me, and I'm going to be stuck with a prop (rather than a jet) due to cost. The fewer inches we go below the surface, the better. So 1648 and a 9.9...a pretty good bet? [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Draft difference: Flat bottom vs. Mod Vee
Top