TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Evinrude/Johnson fuel connector too small for engine side?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="SAABologist" data-source="post: 489827" data-attributes="member: 31667"><p>I have a 1989 Evinrude 8hp, model number E8RCEC.</p><p></p><p>I thought all the evinrude/johnson fuel line connectors to the motor were standard. I picked one up at the store, but the hole is too small to fit on the barb on the engine. </p><p></p><p>The connector on the motor is original. It has never been removed or replaced- the factory zip ties are in place. </p><p></p><p>The size of the metal ball and o-ring are the same, the only issue is the hole of the connector is too small for the barb on the motor. </p><p></p><p>The barb on the motor appears to be exactly 1/4" diameter as is the hole on the original connector I am trying to replace. </p><p></p><p>Does anyone know what's going on with the size of the Evinrude connectors?</p><p></p><p>Thanks much,</p></blockquote><p></p>
[QUOTE="SAABologist, post: 489827, member: 31667"] I have a 1989 Evinrude 8hp, model number E8RCEC. I thought all the evinrude/johnson fuel line connectors to the motor were standard. I picked one up at the store, but the hole is too small to fit on the barb on the engine. The connector on the motor is original. It has never been removed or replaced- the factory zip ties are in place. The size of the metal ball and o-ring are the same, the only issue is the hole of the connector is too small for the barb on the motor. The barb on the motor appears to be exactly 1/4" diameter as is the hole on the original connector I am trying to replace. Does anyone know what's going on with the size of the Evinrude connectors? Thanks much, [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Evinrude/Johnson fuel connector too small for engine side?
Top