TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
figuring casting deck and floor
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="acwd" data-source="post: 237205" data-attributes="member: 7495"><p>There is these tabs where the factory seats riveted in and going by them theres about 1 and 3/4 inch difference between the rear of the rear seat and the front of the front seat. Mind you this thing is 3 foot deep from the top of the boat to the bottom of the hull. I plan on using 1/2 inch plywood for decking well supported and putting the battery or batteries up front. The biggest motor I plan on using is a 1958 Mercury 20 HP on one lake that I go to but the rest are going to be a 9.9 hp on the 10 hp limit lakes. I plan on putting a livewell/seat in the middle of the boat centered from side to side and little to the back of the boat end to end. Use the the area under the front deck for storage for life jackets and such. Hope that gives you idea how things will lay in the boat. Will have a bow mount trolling motor and maybe a anchor havent decide on that yet dont use the one I got in my smaller boat.</p></blockquote><p></p>
[QUOTE="acwd, post: 237205, member: 7495"] There is these tabs where the factory seats riveted in and going by them theres about 1 and 3/4 inch difference between the rear of the rear seat and the front of the front seat. Mind you this thing is 3 foot deep from the top of the boat to the bottom of the hull. I plan on using 1/2 inch plywood for decking well supported and putting the battery or batteries up front. The biggest motor I plan on using is a 1958 Mercury 20 HP on one lake that I go to but the rest are going to be a 9.9 hp on the 10 hp limit lakes. I plan on putting a livewell/seat in the middle of the boat centered from side to side and little to the back of the boat end to end. Use the the area under the front deck for storage for life jackets and such. Hope that gives you idea how things will lay in the boat. Will have a bow mount trolling motor and maybe a anchor havent decide on that yet dont use the one I got in my smaller boat. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
figuring casting deck and floor
Top