TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Free Late 50’s Johnson 35 HP Seahorse motor
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Slimcowboy1978" data-source="post: 485228" data-attributes="member: 23997"><p>Ohh I’m sure it’s a crack… oil poured out even through the JB Weld crap the PO put on it. I welded it all up yesterday and am in the finishing stages of machining it all down smooth again. </p><p></p><p>[ATTACH=full]109959[/ATTACH][ATTACH=full]109958[/ATTACH] [ATTACH=full]109960[/ATTACH]</p><p></p><p>I’ll look around FleeBay and see what I can for the spaghetti seal. Thanks Pappy, I’m going to run a compression test this week, and see if this motor will start… so far it looks like it was gone through very recently, so I’m more inclined that it has been sitting because the gear case was cracked and not holding oil.</p></blockquote><p></p>
[QUOTE="Slimcowboy1978, post: 485228, member: 23997"] Ohh I’m sure it’s a crack… oil poured out even through the JB Weld crap the PO put on it. I welded it all up yesterday and am in the finishing stages of machining it all down smooth again. [ATTACH type="full" alt="9D2D6E0B-D7A3-4A1B-BA8B-775D2CA1637F.jpeg"]109959._xfImport[/ATTACH][ATTACH type="full" alt="769643E7-A78D-4C35-8D62-73758C7CFB08.jpeg"]109958._xfImport[/ATTACH] [ATTACH type="full" alt="D3C12C49-FD96-4073-A7A4-41EF5D5D4FF7.jpeg"]109960._xfImport[/ATTACH] I’ll look around FleeBay and see what I can for the spaghetti seal. Thanks Pappy, I’m going to run a compression test this week, and see if this motor will start… so far it looks like it was gone through very recently, so I’m more inclined that it has been sitting because the gear case was cracked and not holding oil. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Free Late 50’s Johnson 35 HP Seahorse motor
Top