TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Give me some opinions
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="sbritt23" data-source="post: 306635" data-attributes="member: 11029"><p>i was thinking of doing that but either way the wire would have to come out the back by the battery so then i would have 2 wires showing trying to make it look a little clean i think im going to cut a small hole in the storage box up front and take a look hopefully the whole underside of the deck isnt full of foam. if its not then under the trolling motor bracket im thinking of putting a hole big enough for a peice of pvc to pop out with a cap on it with the wires going down on the inside and silicone it so water cant get in the foam. or something along them lines trying not to mess up a brand new boat too bad. Just trying to do a clean install</p></blockquote><p></p>
[QUOTE="sbritt23, post: 306635, member: 11029"] i was thinking of doing that but either way the wire would have to come out the back by the battery so then i would have 2 wires showing trying to make it look a little clean i think im going to cut a small hole in the storage box up front and take a look hopefully the whole underside of the deck isnt full of foam. if its not then under the trolling motor bracket im thinking of putting a hole big enough for a peice of pvc to pop out with a cap on it with the wires going down on the inside and silicone it so water cant get in the foam. or something along them lines trying not to mess up a brand new boat too bad. Just trying to do a clean install [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Give me some opinions
Top