TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Hard areas to sand....
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="WaltonsMountain" data-source="post: 105252" data-attributes="member: 1946"><p>I have mostly finished sanding the exterior hull, bow, transom, and sides of my 12'. What can I use to get in the crevaces though? I want the complete sand job and have been going down to bare aluminum. My orbital wont reach certain areas like around bolts or underneath handles, etc. I was thinking possibly a chemical stripper? Is this the way to go?</p></blockquote><p></p>
[QUOTE="WaltonsMountain, post: 105252, member: 1946"] I have mostly finished sanding the exterior hull, bow, transom, and sides of my 12'. What can I use to get in the crevaces though? I want the complete sand job and have been going down to bare aluminum. My orbital wont reach certain areas like around bolts or underneath handles, etc. I was thinking possibly a chemical stripper? Is this the way to go? [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Hard areas to sand....
Top