TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Has anybody here done conversions on a aluminum run-about?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="nick4634" data-source="post: 100737" data-attributes="member: 1892"><p>alright so its pretty easy to take part of the cover off. I started by taking the windshield off, it was held on by some screws and bolts. Then I disconnected all the electronics, fishfinder, fuse panel, toggle switches etc. Then i cut out the board on either side and pulled it out along with the pulley steering. Then I used a circular saw and just cut out as much as I needed 18 inches forward and left 7 inches on each side. I used plywood to go on the edges but I'm sure theres a better way to block the edges. Then I just put some wood under neath to brace it.</p></blockquote><p></p>
[QUOTE="nick4634, post: 100737, member: 1892"] alright so its pretty easy to take part of the cover off. I started by taking the windshield off, it was held on by some screws and bolts. Then I disconnected all the electronics, fishfinder, fuse panel, toggle switches etc. Then i cut out the board on either side and pulled it out along with the pulley steering. Then I used a circular saw and just cut out as much as I needed 18 inches forward and left 7 inches on each side. I used plywood to go on the edges but I'm sure theres a better way to block the edges. Then I just put some wood under neath to brace it. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Has anybody here done conversions on a aluminum run-about?
Top