TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
Jet Boat Projects
He Reigns Mon Ark project
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="He Reigns" data-source="post: 354538" data-attributes="member: 14103"><p>Out with the old and in with the......slightly used. Started to swap out parts tonight. I got the old piston removed and the new one installed. Grabbed the cylinder only to realise some nitwit did not order new gaskets. They are now ordered and I won't have the new fuel pump and oil pump block off plate untill end of week. So I took the time to remove intake and reed valves, cleaned them and reinstalled. This was only a precautionary measure to make sure there are not any vacuum leaks. I thought I would show a homebuilt wrist pin puller. A piece of all thread, couple nuts and a washer along with a big ol socket. Works great!!!</p><p>[attachment=-1]uploadfromtaptalk1401762511290.jpg[/attachment]</p><p>[attachment=-1]uploadfromtaptalk1401762541756.jpg[/attachment]</p></blockquote><p></p>
[QUOTE="He Reigns, post: 354538, member: 14103"] Out with the old and in with the......slightly used. Started to swap out parts tonight. I got the old piston removed and the new one installed. Grabbed the cylinder only to realise some nitwit did not order new gaskets. They are now ordered and I won't have the new fuel pump and oil pump block off plate untill end of week. So I took the time to remove intake and reed valves, cleaned them and reinstalled. This was only a precautionary measure to make sure there are not any vacuum leaks. I thought I would show a homebuilt wrist pin puller. A piece of all thread, couple nuts and a washer along with a big ol socket. Works great!!! [attachment=-1]uploadfromtaptalk1401762511290.jpg[/attachment] [attachment=-1]uploadfromtaptalk1401762541756.jpg[/attachment] [/QUOTE]
Verification
Post reply
Forums
Jet Boats
Jet Boat Projects
He Reigns Mon Ark project
Top