TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
Help deciding what to do with my set up.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="jtf" data-source="post: 465983" data-attributes="member: 22611"><p>My 1648 weldbilt has a canted transom, so there may be 5% or so tilt. Put on a 50/35 short shaft tiller and it needed to be lifted up to the last two sets of motor mount holes high. It planes out at 3/4 power and splash was a problem solved with the splash plate. There is little room between it and the foot fully trimmed down. Gets plenty of water. I don't know if this one would run like yours in the picture!</p><p></p><p>When the foot is tucked all the way in it's very close to plate. As it is trimmed out/up, there is several inches difference.</p></blockquote><p></p>
[QUOTE="jtf, post: 465983, member: 22611"] My 1648 weldbilt has a canted transom, so there may be 5% or so tilt. Put on a 50/35 short shaft tiller and it needed to be lifted up to the last two sets of motor mount holes high. It planes out at 3/4 power and splash was a problem solved with the splash plate. There is little room between it and the foot fully trimmed down. Gets plenty of water. I don't know if this one would run like yours in the picture! When the foot is tucked all the way in it's very close to plate. As it is trimmed out/up, there is several inches difference. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
Help deciding what to do with my set up.
Top