TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
How to get the back of a rivet flat?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Jeeper" data-source="post: 378465" data-attributes="member: 11511"><p>Is it a solid rivet or hollow? If solid do you have a rivet gun? If so make sure to use a bucking bar on the inside while using the gun. This will make it tighten up in the hole while smashing the inside down. Also if the rivet is too long you can use a shorter one. Good luck</p></blockquote><p></p>
[QUOTE="Jeeper, post: 378465, member: 11511"] Is it a solid rivet or hollow? If solid do you have a rivet gun? If so make sure to use a bucking bar on the inside while using the gun. This will make it tighten up in the hole while smashing the inside down. Also if the rivet is too long you can use a shorter one. Good luck [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
How to get the back of a rivet flat?
Top