TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
How to make this floor flat?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bamabill" data-source="post: 382120" data-attributes="member: 15102"><p>That's nearly the same configuration I'm using in my Lowe 1648 Makeover. 1 1/2 X1 1/2 X 1/8 6061 aluminum</p><p>angle. I put two 3/16 rivets in the top of the rib near the ends where i had good contact. Then I put</p><p>two #10 SS screws in the</p><p>side of the ribs near the two center channels. I also added a 1x1x1/8 spacer either under a rivet or screw as needed to close any gaps between the angle and rib.</p></blockquote><p></p>
[QUOTE="bamabill, post: 382120, member: 15102"] That's nearly the same configuration I'm using in my Lowe 1648 Makeover. 1 1/2 X1 1/2 X 1/8 6061 aluminum angle. I put two 3/16 rivets in the top of the rib near the ends where i had good contact. Then I put two #10 SS screws in the side of the ribs near the two center channels. I also added a 1x1x1/8 spacer either under a rivet or screw as needed to close any gaps between the angle and rib. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
How to make this floor flat?
Top