TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
How would you make a rudder?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="bassboy1" data-source="post: 31260" data-attributes="member: 55"><p>I made a quick one last winter for a trip. I had a piece of 3/4 ply cut to about 10 by 12. Just a scrap from the shop. Cut another fancy rudder shape on the bandsaw, just cause I could. Cut two triangles out of a piece of 6/4 oak, and used them as gussets. Couple stainless screws, some titebond 3 glue, and a coat of paint, and I was good to go, and I must say it looked purty good too. I used two C-clamps, just because I was using it for two trips. If I was going to make a permanent one, I would have had a lip over the transom, and thumb screws to tighten it.</p></blockquote><p></p>
[QUOTE="bassboy1, post: 31260, member: 55"] I made a quick one last winter for a trip. I had a piece of 3/4 ply cut to about 10 by 12. Just a scrap from the shop. Cut another fancy rudder shape on the bandsaw, just cause I could. Cut two triangles out of a piece of 6/4 oak, and used them as gussets. Couple stainless screws, some titebond 3 glue, and a coat of paint, and I was good to go, and I must say it looked purty good too. I used two C-clamps, just because I was using it for two trips. If I was going to make a permanent one, I would have had a lip over the transom, and thumb screws to tighten it. [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
How would you make a rudder?
Top