TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
I have a bulge in my bottom and would like to remedy it.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="DaleH" data-source="post: 483378" data-attributes="member: 15636"><p>To anneal most hull alloys, 5052 etc., hit it with a Sharpie marker and heat entire area FAST until the Sharpie melts and whack with HUGE rubber mallet over a suitable hardwood block.</p><p></p><p>No need to add any wet rag, as those alloys air and work harden. So if you need to hit it again, make sure you heat it again …</p></blockquote><p></p>
[QUOTE="DaleH, post: 483378, member: 15636"] To anneal most hull alloys, 5052 etc., hit it with a Sharpie marker and heat entire area FAST until the Sharpie melts and whack with HUGE rubber mallet over a suitable hardwood block. No need to add any wet rag, as those alloys air and work harden. So if you need to hit it again, make sure you heat it again … [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
I have a bulge in my bottom and would like to remedy it.
Top