TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
I need professional opinions please!!!!!!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="scedistofisher" data-source="post: 400234" data-attributes="member: 8977"><p>I'm still decking away on my 89 duracraft. Slowly but surely. Anyway last night I thought I finally completed the front desk frame work. I inserted the seat and pin into the receiver yo give it a test run. After climbing up and having a seat I quickly realized that I was too close to the elevated factory installed/ welded deck. With that being said, it will make my foot controller for my trolling motor very difficult and uncomfortable to operate. So, my question is....... should I cut the deck out inside of the rails? My concern in doing that is compromising the structural integrity of the bow. Here's what it looks like :</p></blockquote><p></p>
[QUOTE="scedistofisher, post: 400234, member: 8977"] I'm still decking away on my 89 duracraft. Slowly but surely. Anyway last night I thought I finally completed the front desk frame work. I inserted the seat and pin into the receiver yo give it a test run. After climbing up and having a seat I quickly realized that I was too close to the elevated factory installed/ welded deck. With that being said, it will make my foot controller for my trolling motor very difficult and uncomfortable to operate. So, my question is....... should I cut the deck out inside of the rails? My concern in doing that is compromising the structural integrity of the bow. Here's what it looks like : [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
I need professional opinions please!!!!!!!
Top