TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
I'm Ready
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="elrodphil" data-source="post: 444174" data-attributes="member: 22192"><p>I have a 4x8 sheet of aluminum. To save weight I'm going to cut out a piece to co between the gun boxes from the back bench seat to the place where the boat starts to slope up at the front. After I cut this out I am planning to make a template on how I can make the front piece to fit around the bottom of the ribs to the front of the boat. I want to just use tap screws to screw it in the ribs. I am going to get foam to put under the floor...</p></blockquote><p></p>
[QUOTE="elrodphil, post: 444174, member: 22192"] I have a 4x8 sheet of aluminum. To save weight I'm going to cut out a piece to co between the gun boxes from the back bench seat to the place where the boat starts to slope up at the front. After I cut this out I am planning to make a template on how I can make the front piece to fit around the bottom of the ribs to the front of the boat. I want to just use tap screws to screw it in the ribs. I am going to get foam to put under the floor... [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
I'm Ready
Top