TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
Impeller tolerance
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="dhoganjr" data-source="post: 364684" data-attributes="member: 12925"><p>A stainless doesn't flex as much and can run a little closer tolerance. Did you have the nut tight and washer tabs bent around it. If there was anything between the washers sand , grit or anything else could have caused it. In the water as soon as you fire it up it will pull down if the nut not tight. The key could have got caught as you tightened it not allowing it to seat correctly.</p><p></p><p>Take the shoe off and check everything, make sure it is seated and everything is tight. If it is tight and everything is in place with the correct clearance, it should not hit.</p></blockquote><p></p>
[QUOTE="dhoganjr, post: 364684, member: 12925"] A stainless doesn't flex as much and can run a little closer tolerance. Did you have the nut tight and washer tabs bent around it. If there was anything between the washers sand , grit or anything else could have caused it. In the water as soon as you fire it up it will pull down if the nut not tight. The key could have got caught as you tightened it not allowing it to seat correctly. Take the shoe off and check everything, make sure it is seated and everything is tight. If it is tight and everything is in place with the correct clearance, it should not hit. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
Impeller tolerance
Top