TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
Impeller tolerance
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="dhoganjr" data-source="post: 365258" data-attributes="member: 12925"><p>From your earlier post just wanted to make sure they were on the correct side. If it is rubbing any at all out of water it will flex a bit under load and rub more in the water. Try them all on the nut side and see where you are. Unless the bearings are not completely seated or you have a bent shaft everything should line up correctly. You said the bearings were installed correctly so I would rule that out. </p><p></p><p>About the play in the shaft, I don't think mine has any play. Did you get a new Teflon or plastic sleeve with the impeller, goes between impeller and shaft and has a slot for the key to fit in. </p><p></p><p>Hope I am helping you, I know it is frustrating when things aren't working correctly.</p></blockquote><p></p>
[QUOTE="dhoganjr, post: 365258, member: 12925"] From your earlier post just wanted to make sure they were on the correct side. If it is rubbing any at all out of water it will flex a bit under load and rub more in the water. Try them all on the nut side and see where you are. Unless the bearings are not completely seated or you have a bent shaft everything should line up correctly. You said the bearings were installed correctly so I would rule that out. About the play in the shaft, I don't think mine has any play. Did you get a new Teflon or plastic sleeve with the impeller, goes between impeller and shaft and has a slot for the key to fit in. Hope I am helping you, I know it is frustrating when things aren't working correctly. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
Impeller tolerance
Top