TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
installing seat base on G3 1548 VBW
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="riverbud55" data-source="post: 362307" data-attributes="member: 873"><p>Thanks for the reply,,,,was kinda thinking the same thing,,,,,,was thinking maybe of getting some 1/4'' rivnuts for the outer 2 ,,,mite drill and countersink some extra hold down ,,, not a lot of stress on the outer 2 as compared with what the center one will have to deal with, plan on putting like maybe 20'' extension seat pole,,,, own a sheetmetal/weld shop so beefing it up wont be a big problem,,,,, at this point thinking of adding a aluminum 3/16'' formed up doubler plate say 20'' wide X the width of the seat and then bend over the ends 2 or 3 inches with holes so they go into the side also,,, think the rivnuts maybe the way to go on that also,,,, not to crazy about welding something up that has foam behind it</p></blockquote><p></p>
[QUOTE="riverbud55, post: 362307, member: 873"] Thanks for the reply,,,,was kinda thinking the same thing,,,,,,was thinking maybe of getting some 1/4'' rivnuts for the outer 2 ,,,mite drill and countersink some extra hold down ,,, not a lot of stress on the outer 2 as compared with what the center one will have to deal with, plan on putting like maybe 20'' extension seat pole,,,, own a sheetmetal/weld shop so beefing it up wont be a big problem,,,,, at this point thinking of adding a aluminum 3/16'' formed up doubler plate say 20'' wide X the width of the seat and then bend over the ends 2 or 3 inches with holes so they go into the side also,,, think the rivnuts maybe the way to go on that also,,,, not to crazy about welding something up that has foam behind it [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
installing seat base on G3 1548 VBW
Top