TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Is my motor done?????? New Motor!!!!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Troutman3000" data-source="post: 145826" data-attributes="member: 2535"><p>Think I found the culprit of my motor problems. The engine started acting up again today. It was the first time I ran it without the gumout in the tank so at first I thought it was the carbs. Well then I ran it at home and found this. </p><p> </p><p>A bolt broke off because it was rusted, and I found water was already leaking where it was supposed to make a seal. Now half of the bolt is still in the motor. There is a steady stream from the bolt hole and the gasket. Is there any hope or am I just stuck. Could I use jbweld?</p><p> </p><p>Any help would be much appreciated.</p></blockquote><p></p>
[QUOTE="Troutman3000, post: 145826, member: 2535"] Think I found the culprit of my motor problems. The engine started acting up again today. It was the first time I ran it without the gumout in the tank so at first I thought it was the carbs. Well then I ran it at home and found this. A bolt broke off because it was rusted, and I found water was already leaking where it was supposed to make a seal. Now half of the bolt is still in the motor. There is a steady stream from the bolt hole and the gasket. Is there any hope or am I just stuck. Could I use jbweld? Any help would be much appreciated. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Is my motor done?????? New Motor!!!!!
Top