TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
Jet motor raising question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Creekchub" data-source="post: 501643" data-attributes="member: 26052"><p>For reference, I just got the impeller sharpened and the foot back on. The T square is flat along the hull and the leading edge of the foot is about 3/4 of an inch too low now. I think the boat should perform a little better up one hole, hopefully. The center keel sits right in front of the foot too. Not sure if that’ll matter after I raise the motor</p></blockquote><p></p>
[QUOTE="Creekchub, post: 501643, member: 26052"] For reference, I just got the impeller sharpened and the foot back on. The T square is flat along the hull and the leading edge of the foot is about 3/4 of an inch too low now. I think the boat should perform a little better up one hole, hopefully. The center keel sits right in front of the foot too. Not sure if that’ll matter after I raise the motor [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
Jet motor raising question
Top