TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Jet Boats
General Jet Boat Discussions
Just swapped a Honda 30hp prop for a Evinrude 48/35 jet
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="handyandy" data-source="post: 429163" data-attributes="member: 18942"><p>If it has the vro automixing just ditch that and premix your oil with the gas 50:1 make sure to use tcw3 oil of some kind if it meets tcw3 certification than it should be fine. Make sure to check the impeller and the clearance and get the transome height set correctly jets are finicky about what they like to be at a little to low causes drag and splash back but little too high causes cavitation.</p></blockquote><p></p>
[QUOTE="handyandy, post: 429163, member: 18942"] If it has the vro automixing just ditch that and premix your oil with the gas 50:1 make sure to use tcw3 oil of some kind if it meets tcw3 certification than it should be fine. Make sure to check the impeller and the clearance and get the transome height set correctly jets are finicky about what they like to be at a little to low causes drag and splash back but little too high causes cavitation. [/QUOTE]
Verification
Post reply
Forums
Jet Boats
General Jet Boat Discussions
Just swapped a Honda 30hp prop for a Evinrude 48/35 jet
Top