TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Keel question
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="ACAMS" data-source="post: 401814" data-attributes="member: 20331"><p>It is a 15" motor, and I am thinking of setting it back about 4" so I can raise it up a little too.</p><p></p><p>I have a CMC tilt trim unit I am thinking about modifying to weight a lot less and be closer, and also relocate the pump to inside the boat.</p><p></p><p>The 15" motors are very hard to put tilt trim on and didn't come from factory with it.</p><p></p><p>I may just wedge it up a couple inches and call that good enough ...... still in planning stage!</p></blockquote><p></p>
[QUOTE="ACAMS, post: 401814, member: 20331"] It is a 15" motor, and I am thinking of setting it back about 4" so I can raise it up a little too. I have a CMC tilt trim unit I am thinking about modifying to weight a lot less and be closer, and also relocate the pump to inside the boat. The 15" motors are very hard to put tilt trim on and didn't come from factory with it. I may just wedge it up a couple inches and call that good enough ...... still in planning stage! [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Keel question
Top