TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
"Krazy Kajun" 1993 Lowe 1648 / 93' 25 HP Mercury FINISHED!!!
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Livetofish" data-source="post: 327912" data-attributes="member: 12513"><p>UPDATE # 6</p><p></p><p>Well, some progress has been made. Both front and rear decks are now framed up and ready to start cutting the 1/2 plywood for the front deck. From there I will be cutting the sides for the gunnels out of 3/8" material. I have decided to have 2 seats on the back seat in whiich one of them will be removalble so a pedalstel chair with a 11" post can be dropped into the base plate. I have not decided to use the trolling motor mount that was fabricated from 1/2" starboard becuase the front deck will nearly be flush with the top rail. Last night I ordered my bus bars, bilge pumps, plumbing kit, 3 toggle marine switch panel and the 12Volt plug. Will be running wiring later this evening after it cools off.... 98 degrees and 96 % Humidity!!!!!!!!!!!! It's freaking hot today.</p><p>Will post up after the weekend with update # 7</p></blockquote><p></p>
[QUOTE="Livetofish, post: 327912, member: 12513"] UPDATE # 6 Well, some progress has been made. Both front and rear decks are now framed up and ready to start cutting the 1/2 plywood for the front deck. From there I will be cutting the sides for the gunnels out of 3/8" material. I have decided to have 2 seats on the back seat in whiich one of them will be removalble so a pedalstel chair with a 11" post can be dropped into the base plate. I have not decided to use the trolling motor mount that was fabricated from 1/2" starboard becuase the front deck will nearly be flush with the top rail. Last night I ordered my bus bars, bilge pumps, plumbing kit, 3 toggle marine switch panel and the 12Volt plug. Will be running wiring later this evening after it cools off.... 98 degrees and 96 % Humidity!!!!!!!!!!!! It's freaking hot today. Will post up after the weekend with update # 7 [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
"Krazy Kajun" 1993 Lowe 1648 / 93' 25 HP Mercury FINISHED!!!
Top