TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Jon and V Boat Conversions & Modifications
Lund SSV 18
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="stomper" data-source="post: 483696" data-attributes="member: 12788"><p>Sorry for the late reply, I haven't been on here much lately.</p><p>The vinyl covered bow peice was original from the factory but could easily be made. Whats holding it on is some small aluminum angle brackets beneath it that are riveted to the sides of the boat. Its no where near the water line so standard pop rivets could be used for the brackets. As for the wooden verticle peice, I made that out of MDO and attached it to the casting deck and the underside of the bow peice using a couple peices of aluminum angle. I had actually bought vinyl to cover it but the original vinyl is faded some and it wouldn't match. Leaving it the wood colour matches the the seat tops so it doees'nt look all that bad.</p></blockquote><p></p>
[QUOTE="stomper, post: 483696, member: 12788"] Sorry for the late reply, I haven't been on here much lately. The vinyl covered bow peice was original from the factory but could easily be made. Whats holding it on is some small aluminum angle brackets beneath it that are riveted to the sides of the boat. Its no where near the water line so standard pop rivets could be used for the brackets. As for the wooden verticle peice, I made that out of MDO and attached it to the casting deck and the underside of the bow peice using a couple peices of aluminum angle. I had actually bought vinyl to cover it but the original vinyl is faded some and it wouldn't match. Leaving it the wood colour matches the the seat tops so it doees'nt look all that bad. [/QUOTE]
Verification
Post reply
Forums
Boats
Jon and V Boat Conversions & Modifications
Lund SSV 18
Top