TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Motor not running right
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Johny25" data-source="post: 291462" data-attributes="member: 7791"><p>yes they could be leaking if not seated correctly. I usually set them with the rounded blunt end of a ratchet extension, using it like a punch to indent and seat then well. One good whack usually does the trick. </p><p></p><p> Do you have good plugs? What is your fuel mix ratio you are running? Did you set slow speed idle adjustment while engine was in the water, on the boat, in gear at lowest idle? And did you check reeds when you did conversion, and did you replace intake manifold gasket, carb gasket and reed plate gasket when you did conversion?</p></blockquote><p></p>
[QUOTE="Johny25, post: 291462, member: 7791"] yes they could be leaking if not seated correctly. I usually set them with the rounded blunt end of a ratchet extension, using it like a punch to indent and seat then well. One good whack usually does the trick. Do you have good plugs? What is your fuel mix ratio you are running? Did you set slow speed idle adjustment while engine was in the water, on the boat, in gear at lowest idle? And did you check reeds when you did conversion, and did you replace intake manifold gasket, carb gasket and reed plate gasket when you did conversion? [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Motor not running right
Top