TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Electrical
Mounting a cutting board for a tranducer + troubleshooting
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="user 7806" data-source="post: 246458" data-attributes="member: 7806"><p>When mounting the cutting boad to mount the tranducer on do you bolt through the tramsom or just use a couple of sheet metal screws, stainless steel naturally.</p><p></p><p>Also the weld at the seam on the bottom of the transom and the bottom of the boat is such that it there is a ridge there across the entire bottom of the boat. I'm thinking this will cause turblance all across the back and make it real hard to get a transduce to work right. This weld probably is 1/16-/18 below the actual bottom of the boat.</p><p></p><p>Mine currently is mounted to the transom and when going slow or idling the depth reads fine. When you start running faster at a point the depth display will start blinking and continue this until you slow down. </p><p></p><p>Any suggestions as to what I need to do here?</p></blockquote><p></p>
[QUOTE="user 7806, post: 246458, member: 7806"] When mounting the cutting boad to mount the tranducer on do you bolt through the tramsom or just use a couple of sheet metal screws, stainless steel naturally. Also the weld at the seam on the bottom of the transom and the bottom of the boat is such that it there is a ridge there across the entire bottom of the boat. I'm thinking this will cause turblance all across the back and make it real hard to get a transduce to work right. This weld probably is 1/16-/18 below the actual bottom of the boat. Mine currently is mounted to the transom and when going slow or idling the depth reads fine. When you start running faster at a point the depth display will start blinking and continue this until you slow down. Any suggestions as to what I need to do here? [/QUOTE]
Verification
Post reply
Forums
Boats
Electrical
Mounting a cutting board for a tranducer + troubleshooting
Top