TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Need help with 90hp evinrude
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Fordracing2105" data-source="post: 387545" data-attributes="member: 13217"><p>I pulled the carbs and like you said I didn't pull the hs jets. I did blow and stick a wire in them. I remember that but there is plenty of room for gunk to build up behind them. Clean them again and took to the river. Boat ran great for a little while than the motor slowed and about locked up. I tried to start it but starter would barely turn over the motor. Waited alittle it now turns over a little faster but won't start. I came home and checked compression and is 95 112 112 115. I'm pretty sure the last time I checked the cylinder was up around 112 or 115. Pulled plugs there nice and tan or light brown looking doesn't seam to be lean. I guess I'm going to check starter spark and battery now.</p></blockquote><p></p>
[QUOTE="Fordracing2105, post: 387545, member: 13217"] I pulled the carbs and like you said I didn't pull the hs jets. I did blow and stick a wire in them. I remember that but there is plenty of room for gunk to build up behind them. Clean them again and took to the river. Boat ran great for a little while than the motor slowed and about locked up. I tried to start it but starter would barely turn over the motor. Waited alittle it now turns over a little faster but won't start. I came home and checked compression and is 95 112 112 115. I'm pretty sure the last time I checked the cylinder was up around 112 or 115. Pulled plugs there nice and tan or light brown looking doesn't seam to be lean. I guess I'm going to check starter spark and battery now. [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Need help with 90hp evinrude
Top