TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Motors
Need some serious help with my 1993 20hp 2stroke merc
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="scoobeb" data-source="post: 413498" data-attributes="member: 6843"><p>Everything is 100% brand new as far as lines,gaskets,etc.I checked it again today and i saw no daylight in any gaskets.I'm going to have to revisit the carb and check over everything once again step by step.The most frustrating thing is it runs so freaken awesome, i just can't get it to open up more than 15 seconds at wot without pumping the ball.I put a whole new carb diaphragm kit in just a month ago.I guess what i must do is tear down the carb again and inspect it all again.Would like the needle cause this,or like the float,or jets,anything else but like a air leak as you said or pin hole in one of the gaskets.I put everything back together as it should be.I will retrace everything like i said.</p><p></p><p>I bet it's something so stupid and easy.I can't seem to find the fuel pump for this outboard,it's obsolete,so i don't know what to do there.This is crazy.Maybe it's a defective male engine gas connect that i just put on the engine a month ago.All i know is when i pump the ball on either of the 2 brand new tanks or line i use it would get rock hard then in time it just seems like it goes limp unless i keep pumping it.</p><p></p><p>If it had an air leak wouldn't i see a gas leak somewhere?</p></blockquote><p></p>
[QUOTE="scoobeb, post: 413498, member: 6843"] Everything is 100% brand new as far as lines,gaskets,etc.I checked it again today and i saw no daylight in any gaskets.I'm going to have to revisit the carb and check over everything once again step by step.The most frustrating thing is it runs so freaken awesome, i just can't get it to open up more than 15 seconds at wot without pumping the ball.I put a whole new carb diaphragm kit in just a month ago.I guess what i must do is tear down the carb again and inspect it all again.Would like the needle cause this,or like the float,or jets,anything else but like a air leak as you said or pin hole in one of the gaskets.I put everything back together as it should be.I will retrace everything like i said. I bet it's something so stupid and easy.I can't seem to find the fuel pump for this outboard,it's obsolete,so i don't know what to do there.This is crazy.Maybe it's a defective male engine gas connect that i just put on the engine a month ago.All i know is when i pump the ball on either of the 2 brand new tanks or line i use it would get rock hard then in time it just seems like it goes limp unless i keep pumping it. If it had an air leak wouldn't i see a gas leak somewhere? [/QUOTE]
Verification
Post reply
Forums
Boats
Motors
Need some serious help with my 1993 20hp 2stroke merc
Top