TinBoats.net
The original aluminum boat site!
Forums
New posts
Search forums
Blog
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Members
Current visitors
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Menu
Log in
Register
Install the app
Install
Forums
Boats
Boat House
Pedestal Seat Mounting Options
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support TinBoats.net:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="delmonte67" data-source="post: 76019" data-attributes="member: 575"><p>Yes I did have to drill the holes larger, I pinched/folded the clamps on each side against the main bolt, that gave me my diameter/circumfrence for the holes. Start your holes slightly smaller and carefully work your bit around the perimeter of the hole to cut to size. You want the smallest holes so that your "pinched" toggle bolt just fits in. And I had no problem at all with these biting/grabbing hold underneath- Make it tight as hell! Be sure to dig out any foam if there is any inside, to make room for the toggle bolt to go down into the hole. After you put your bolt through the seat base, and then screw your toggle on the bolt and then get ready to pinch/fold it into the hole, make sure the toggle is screwed on 3-4 spins, you dont want it falling off the end and losing it in the hole. Hope this helps! D. 8)</p></blockquote><p></p>
[QUOTE="delmonte67, post: 76019, member: 575"] Yes I did have to drill the holes larger, I pinched/folded the clamps on each side against the main bolt, that gave me my diameter/circumfrence for the holes. Start your holes slightly smaller and carefully work your bit around the perimeter of the hole to cut to size. You want the smallest holes so that your "pinched" toggle bolt just fits in. And I had no problem at all with these biting/grabbing hold underneath- Make it tight as hell! Be sure to dig out any foam if there is any inside, to make room for the toggle bolt to go down into the hole. After you put your bolt through the seat base, and then screw your toggle on the bolt and then get ready to pinch/fold it into the hole, make sure the toggle is screwed on 3-4 spins, you dont want it falling off the end and losing it in the hole. Hope this helps! D. 8) [/QUOTE]
Verification
Post reply
Forums
Boats
Boat House
Pedestal Seat Mounting Options
Top